Welcome to Our Community

Some features disabled for guests. Register Today.

Cnc Mill using standard and 3d printed cimponents

Discussion in 'CNC Mills/Routers' started by TRMA-Chaser, Aug 26, 2019.

  1. TRMA-Chaser

    Builder

    Joined:
    Aug 4, 2019
    Messages:
    2
    Likes Received:
    3
    TRMA-Chaser published a new build:

    Read more about this build...
     
  2. Enterprise

    Builder

    Joined:
    Jan 15, 2018
    Messages:
    1
    Likes Received:
    0
    Looks similar to one I made. I did not care for the gantry type that has two motors to move the X axis back and forth. With a stationary X axis, you will probably want to put the X axis mount in the middle instead of on the end. Your table will not give you enough movement in both directions, otherwise.
     
  3. TRMA-Chaser

    Builder

    Joined:
    Aug 4, 2019
    Messages:
    2
    Likes Received:
    3
    good point with the X Axis positioning will take a look at it once i can assemble it completly
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice