Welcome to Our Community

Some features disabled for guests. Register Today.

      1. Build Progress:
        • Build in Progress...
      Rate This Build
      0/5,
      0 votes
      Initial Post
      1-11-2020

      Getting started on the build, design complete, less the details on the router mount.

      Started with a deal on some FUYU 800 mm linear rail assemblies and a Long's Motor motor driver kit.
      This led me to use the linear rails and ball screws used on the Y axis. This is the reason for the MGW12 rail blocks on the Y-axis. If I don't like them I'll replace eventually.

      Full Assembly v85_2.png

      I had previously purchased some C-Beam and 8020 extrusions from Openbuilds, so I used these for the base assembly. The 1/8 plates are added to reinforce the 8020 and 2040 side rails. I still need to design end braces. I may 3D print some until I get a spindle and can mill them.

      Full Assembly v85_2.png Full Assembly v85_3.png Full Assembly v85_4.png

      Base is complete. It's a 4" torsion table on a 24" cabinet. I wanted it on the low side to allow easy reach across the router and to allow room for a future enclosure.

      Parts list is still a work in progress. Prices reflect what I paid, not retail.

      IMG_4410.jpg IMG_4423.jpg IMG_4428.jpg
      gummie45 likes this.
  • Loading...
  • Build Details

    Build License:
    • CC - Attribution - CC BY

    Reason for this Build

    Primary use will be wooden sheet goods. Would like to add add non-ferrous milling eventually

    Inspired by

    RigidOko
  • Attached Files:

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice